Need help?Do you have a question about the HP J9980A and is the answer not in the manual?
General| Category | Switch |
|---|---|
| Jumbo Frame Support | Yes |
| PoE | No |
| Layer | Layer 2 |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Storage Temperature | -40°C to 70°C (-40°F to 158°F) |
| Model | J9980A |
| Uplink Ports | 4 |
| MAC Address Table Size | 16, 000 entries |
| Management | Web, SNMP, CLI |
| Form Factor | Rack-mountable |
| Power Supply | Internal |
| Humidity | 5% to 95% (noncondensing) |
Details how to connect the switch to a network for management access via IP.
Configures network interface settings like IP address, subnet mask, and gateway.
Manually or automatically sets the system time using SNTP.
Manages port operational settings, status, and configuration.
Monitors network traffic by copying source port traffic to a destination port.
Explains Spanning Tree Protocol (STP) for preventing network loops.
Provides automatic detection and prevention of network loops.
Manages VLAN definitions, views their status, and adds new VLANs.
Assigns ports to VLANs and configures participation/tagging settings.
Manages link aggregation groups (LAGs) by configuring trunks.
Details the PoE and PoE+ specifications supported by the switches.
Configures global PoE power management modes and status.
Manages PoE status, priority, and high power mode per port.
Adjusts individual port PoE parameters like power limit and status.
Configures DoS protection, storm control, and other security features.
Enables and configures secure HTTP (HTTPS) access to the switch.
Configures Efficient Ethernet (EEE) for per-port power saving.
Configures buffered logging and Syslog forwarding for system messages.
Performs a software reboot of the switch.
Restores all switch settings to their default factory values.
Manages switch image and configuration backups and updates.
To Next Page
