To Next PageTo Next Page
Need help?Do you have a question about the HP J9728A and is the answer not in the manual?
General| Product Number | J9728A |
|---|---|
| Device Type | Switch |
| Management Type | Managed |
| Layer | Layer 3 |
| Form Factor | Rack-mountable |
| Power Supply | Internal |
| Weight | 7.5 lb |
| Switching capacity | 128 Gbps |
| Forwarding rate | 35.7 Mpps |
| Jumbo Frame Support | Yes |
| Input Voltage | 100-240 VAC |
| Model | HP J9728A |
| Category | Switch |
| Management | Managed |
| VLAN Support | Yes |
| Layer 3 Support | Yes |
| PoE Support | No |
| Ports | 24 x 10/100/1000 |
| Dimensions (W x D x H) | 44.25 x 24.64 x 4.39 cm |
Details commands for IGMP configuration and status display.
Shows how to display IGMP configuration for specific or all VLANs.
Displays IGMP configuration for all VLANs on the switch.
Enables creation of static and null routes.
Provides commands for configuring static IP routes.
Assigns the default route for non-local traffic.
Allows multiple equal-cost paths to the same destination.
Describes how to configure RIP using the CLI interface.
Procedure to configure RIP parameters system-wide and per VLAN.
Details methods to enable RIP, setting default version to RIPv2-only.
Enables IP address and parameter configuration for hosts.
Adds DHCP server IP addresses for specified VLANs.
Configures forwarding of client UDP broadcasts to target servers.
Steps to configure and enable UDP broadcast forwarding.
Enables or disables UDP broadcast forwarding globally.
