Covers and external components
This section contains instruction for removing and replacing printer covers and external
components.
Rear cover
Use the following steps to remove the rear cover of the printer.
To remove the rear cover
1. Remove the two screws shown in callout 1.
2. Pull out slightly on the bottom of the rear cover, and slide it toward the right side of the
printer to remove it.
Figure 6-3.
Removing and replacing the rear cover
Top cover
Use the following steps to remove the top cover of the printer.
To remove the top cover
1. Lift the top cover and remove the fuser. See Replacing the fuser for instructions on
removing the fuser.
WARNING!
The fuser might be hot. Wait 10 minutes for it to cool down before removing it.
2. Using fingers or needle-nose pliers, pinch and release the white plastic clips (shown in
callout 1) on the damper arm on the left side of the cover. It is easier to pinch these clips
if you tip the top cover forward.
3. Remove the screw shown in callout 2 and remove the retaining block.
190 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...