6. Remove the six screws shown in callout 1, and remove the drum drive grounding plate.
Figure 6-37.
Removing and replacing the drum drive gears (1 of 2)
7. Remove the four drum drive gears, shown in callout 2.
Note
The drive gears for the cyan and magenta drum drive units have longer shafts than for the
yellow and black drum drive units.
8. Remove the two screws and the two disengaging rod retainers shown in callout 3.
9. Move the disengaging rod up until it disengages from the gear, and pull the arm out
(callout 4).
Note
See the Reinstallation tip for helpful information on reinstalling the developing disengaging
rod.
Figure 6-38.
Removing and replacing the drum drive gears (2 of 2)
Note
Calibrate the printer after removing and replacing any of the drum drive gears. See Calibrate
now.
214 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...