5. On the drum drive unit that you wish to remove, disconnect the appropriate connector
shown in callout 4.
Figure 6-41.
Removing and replacing the drum drive assemblies (3 of 4)
6. Remove the four screws shown in callout 5.
7. Remove the drum drive assembly.
Figure 6-42.
Removing and replacing the drum drive assemblies (4 of 4)
Note
Calibrate the printer after removing and replacing any of the drum drive assemblies. See
Calibrate now.
Reinstallation tip
When reinstalling the developing disengaging rod, be sure to rotate the white gear (located
between the black and magenta drum drive units) fully clockwise until it comes to a complete
stop, as indicated in callout 6 below.
216 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...