Note
Failure to position the gear properly will result in improper printer operation and possible
print quality defects.
Also make sure the developing disengaging rod passes through the slots in the drive
clutches (in the up position, callout 7) in each of the four drum drive units, engaging each
clutch. The clutch on the yellow drum drive unit is particularly difficult to see and engage
properly.
Figure 6-43.
Reinstalling the developing disengaging rod (1 of 2)
Figure 6-44.
Reinstalling the developing disengaging rod (2 of 2)
E-label memory controller PCB
Use the following steps to remove the e-label memory controller PCB.
ENWW Internal components (left side) 217
To Next Page
Loading...