10. Remove the formatter case
Figure 6-57.
Removing and replacing the formatter case (2 of 2)
Laser/scanner units
Use the following steps to remove and replace the laser/scanner units.
To remove the laser/scanner cover plate
1. Remove the rear cover. See Rear cover.
2. Remove the top cover. See
Top cover.
3. Remove the rear top cover. See
Rear top cover.
4. Remove the left cover. See
Left cover.
5. Remove the DC controller shield. See
DC controller shield.
6. Remove the right cover. See
Right cover.
7. Remove the formatter case. See
Formatter case.
8. At the rear of the printer, place the cardboard spacer (included with the laser/scanner
unit) underneath the V mark on the bottom of the printer frame, as shown in callout 1.
CAUTION
Always place the spacer under the printer frame. This spacer is important to support the
printer and keep it from flexing when the plate that covers the laser/scanners is removed. If
the printer frame flexes, the laser beams may become skewed, resulting in print quality
problems.
ENWW Internal components (rear) 227
To Next Page
Loading...