9. Remove the seven screws shown in callout 2.
Figure 6-58.
Removing and replacing the laser/scanner units (1 of 8)
10. Using needle-nose pliers, unhook the right end of the wire clip, then release the left side
of the clip from the bracket. Repeat this procedure for each of the four clips.
11. Remove the plate that covers the laser/scanner units.
Figure 6-59.
Removing and replacing the laser/scanner units (2 of 8)
Reinstallation tip
When reinserting the four wire clips, insert the left end of the clip first, thread the clip
under the center notch, and then insert the right end of the clip.
12. Disconnect the four laser/scanner connectors from the DC controller (callout 3).
228 Chapter 6 Removal and replacement ENWW
To Next Page
Loading...