13. Unwind the cables from the stays, and thread the connectors through the slot so they
are free of the printer frame.
Figure 6-60.
Removing and replacing the laser/scanner units (3 of 8)
14. On the left side of the printer, remove the screw above the DC controller, shown in
callout 4.
Figure 6-61.
Removing and replacing the laser/scanner units (4 of 8)
15. Grasp the top of the laser/scanner retaining bar where indicated in callout 5, and push it
towards the laser/scanners to release it.
ENWW Internal components (rear) 229
To Next Page
Loading...