HP Laser Jet 5550 - Page 313

Control panel message Event
log error
message
Description Recommended action
REPLACE SUPPLIES
For status press
None At least one supply item is out and
needs to be replaced and another
supply item is either out or low.
1. Press to identify which
supplies should be replaced.
2. Replace the identified
supplies to continue printing.
3.
Press
for detailed
information.
4. Press
and to step
through instructions.
5. Supplies ordering information
is also available from the
embedded Web server.
REPLACE TRANSFER KIT
For help press
None The transfer unit has reached end
of life.
1. Replace the transfer unit to
continue printing.
2.
Press
for detailed
information.
3. Press
and to step
through instructions.
4. Supplies ordering information
is also available from the
embedded Web server.
Resend
upgrade
None The firmware upgrade was not
completed successfully.
Attempt upgrade again.
Rotating <COLOR>
cartridge motor
To exit press
Cancel Job key
None A component test is in progress;
the component selected is <color>
Cartridge motor.
Press S TOP when ready to stop
this test.
Rotating <COLOR> laser scanner
To exit press
the STOP key
None A Scanner test is in progress. PressS TOP when ready to stop this
test.
Rotating...
belt drive
To exit press
Cancel Job key
None The printer is executing a
Component Test and the
component selected is Belt Only.
Press C ANCEL J OB (HP Color
LaserJet 5500) or S
TOP (HP Color
LaserJet 5550) when ready to
stop this test.
Rotating...
fuser motor
To exit press
Cancel Job key
None The printer is testing the
developing disengaging motor.
(This motor is called the
"alienation motor" in firmware
messages.)
Press C ANCEL J OB (HP Color
LaserJet 5500) or S
TOP (HP Color
LaserJet 5550) when ready to
stop this test.
Table 7-3. Alphabetical printer messages (HP Color LaserJet 5550 models) (continued)
ENWW Alphabetical printer messages 291