Menu item Values Description
JOB HELD TIMEOUT OFF
1 HOUR
4 HOURS
1 DAY
1 WEEK
Sets the period of time that the
system keeps files in job
storage before deleting them
from the queue.
SHOW ADDRESS AUTO
OFF
This item determines whether
the printer's IP address is
shown on the display with
Ready. If more than one EIO
card is installed, the IP address
of the card in the first slot is
shown. The default is OFF.
COLOR/MONO MIX= AUTO
MOSTLY COLOR PAGES
MOSTLY BLACK PAGES
AUTO will determine the mode
the engine will go into based on
the first page of the print job. If
the first page is monochrome,
the engin will go into mono
mode until a color page is
detected. It will then continue in
color mode until the end of the
job. If the first page is in color
the engine will go into color
mode for the duration of the job.
MOSTLY COLOR PAGES will
cause the engine to always run
in color mode, even if the
whole job is in monochrome.
MOSTLY BLACK PAGES will
cause the engine to switch
back and forth between color
and monochrome mode. If the
first page is monochrome the
engine will go into mono mode
until a color page is detected. It
then it goes into color mode. If
three consecutive monochrome
pages are detected, the engine
will switch back to
monochrome mode again. If
the first page is color the
engine will go into color mode
until three consecutive
monochrome pages are
detected at which point it will
switch back to monochrome
mode.
TRAY BEHAVIOR userequestedtray
manuallyfeedprompt
Allows you to specify settings
for the tray selection behavior.
(This setting allows you to
configure the trays to behave
like trays in some previous HP
printers.)
Table 7-43. System setup submenu (continued)
378 Chapter 7 Troubleshooting ENWW
To Next Page
Loading...