68 Chapter 3 - Troubleshooting Q1342-90910
Table 9. Status lights messages
Message Possible causes Solutions
The Ready and Attention lights are not
illuminated.
1. Verify that the power cord is
connected to the printer and the power is
turned on.
2. The cable pod is not connected or has
failed. Verify that the cable pod is
connected and fully seated.
3. Replace the cable pod.
4. Replace the LED status panel
assembly.
The Ready and Attention lights blink.
The cable pod is initializing the firmware
or the unit is printing a cleaning page.
No action is needed.
The Ready light illuminates. The printer
is ready to print.
No action is needed. The Ready light
indicates that the cable pod has
initialized the firmware. The firmware is
initialized each time the printer power is
turned on or when the cable pod is
connected to the printer (with the printer
power turned on).
The Ready light blinks. The printer is
receiving and processing data.
Wait for the job to print.
The Attention light blinks. The printer
requires user intervention.
A User Intervention message appears on
the computer screen. Follow the
directions in the message to clear the
error. Possible errors requiring user
intervention are:
z Out of paper
z Media jam
z Toner door open
z Toner cartridge missing
The Ready light illuminates and the
Attention light blinks. The printer is in a
continuable error state.
A User Intervention message appears on
the computer screen. Follow the
directions in this message to clear the
error. "Out of memory" is the continuable
error.
To Next Page
Loading...