EN
Removal and Replacement
: Internal assemblies
100
Paper pick-up assembly removal
Figure 4-39Accessing the Paper Pick-up Assembly Area.
Prior to this step: Remove memory card (if applicable), scanner, pods, front door, front
cover, back cover, paper guide, top cover, and disconnect laser/scanner.
1
Remove the screw attached to a bracket at the right end of the cover plate (callout
1).
2
Remove the two top screws attached to the right and left of the plate(callouts 2
and 3).
3
Remove the two screws located underneath the plate, securing it to the Paper
Pick-up Assembly (callouts 4 and 5).
To Next Page
Loading...