EN
Removal and Replacement
: External assemblies and covers
73
Pod removal
Figure 4-13Removing the Stabilizing Pods.
The pods connected to the bottom of the printer must be removed before the covers of
the printer can be taken off. The end of the pod removal tool marked “L” removes the
left pod; the end of the tool marked “R” removes the right. To release the pods:
1
Insert the pod removal tool into the slot below the corresponding pod and press
firmly.
2
Lift the pods from the frame.
Alternate procedure:
1
Using a small flat head screwdriver, pry the plastic snaps open.
2
Lift the pods from the frame.
To Next Page
Loading...