C4170-90959
Parts Removal Tree
203
3 Install the B-1 belt and roller back in its carriage as shown in figure 7-68. Perform the
same procedure to install the B-2 belt and roller.
Figure 7-68 Installing the B-1 Belt and Roller
4 Insert the non-geared roller shaft through belt C-1.
5 Insert one at a time the ends of the non-geared roller shaft through the A-1 and A-2 belts
while holding down the A-1 and A-2 rollers.
6 Snap the non-geared roller shaft into its carriage.
Figure 7-69 Installing the Non-Geared Roller Shaft
7 Insert the geared roller shaft through belt C-1.
To Next Page
Loading...