ENWW Entering escape characters 171
Entering escape characters
Printer commands always begin with the escape character (?).
The following table shows how the escape character can be entered from various MS-DOS
software programs.
Selecting PCL 5e fonts
The printer font list provides PCL 5e printer commands for selecting fonts. (See “PS or PCL font
list” on page 76 for information about how to print the list.) A sample section is shown below.
There is one variable box for entering symbol sets and one for entering point size. These
variables must be filled in, or the printer will use defaults. For example, if you want a symbol set
that contains line-draw characters, select the 10U (PC-8) or 12U (PC-850) symbol set. Other
common symbol set codes are listed in the table beginning on the next page.
MS-DOS software
programs
Entry What appears
Lotus 1-2-3 Type \027 027
WordPerfect for MS-DOS Type <27> <27>
MS-DOS Edit Hold down Ctrl-P, and press Esc ¨
MS-DOS Edlin Hold down Ctrl-V, release, then press [ ^[
1 Symbol set
2 Point size
Font list
1
2
To Next Page
Loading...