28 Operation C9148-90909
Using the ADF unit
The automatic document feeder (ADF) is a fast, convenient way to feed multiple-page originals
for copying or digital-sending. You can load the ADF with as many as 30 sheets of paper. The
ADF accepts documents that meet the following specifications:
● single-sided or double-sided originals
● documents on standard letter-size, A4-size, and legal-size paper
● documents ranging in size from 148.5 by 210.0 mm (5.9 by 8.3 inches) to 215.9 by
355.6 mm (8.5 by 14.0 inches)
● documents ranging in weight from 50 to 105 g/m
2
(16 to 28lb)
● documents that are free of tears or perforations
● documents that are square or rectangular and in good condition (not fragile or worn)
● documents that are free of glue, correction fluid, wet ink, sticky notes, tape flags, staples, or
paper clips
CAUTION Do not use multipart forms.
The ADF transports the original document through the ADF paper path. Copies made using the
ADF are delivered to the output bin beneath the scan unit.
General guidelines for using the ADF unit
Figure 6. Using the ADF
Note The source documents must be placed in the ADF input with the side you intend to copy facing up.
1 Before placing documents in the ADF, prepare the documents by doing the following:
• flatten curls or wrinkles
• remove staples, paper clips, sticky notes, and similar materials
2 Place documents in the ADF input tray.
3 On the control panel, select the sending or copying options you want to use. See the “Walk-
up copying” and “Sending to e-mail” sections in the use guide for information about these
functions.
4 After making your selections, press
START. Copies are sent to the output bin beneath the
scan unit.
5 When the scan is complete, remove the original document from the ADF output.
To Next Page
Loading...
