220 Appendix B - Control panel menus
EN
CLEARABLE
WARNINGS=JOB
JOB
ON
Set the amount of time that a clearable warning
is displayed on the printer control panel.
JOB
:
Warning messages display on the control
panel until the end of the job from which they
were generated.
ON
:
Warning messages display on the control
panel until G
O
is pressed.
AUTO CONTINUE=
ON
ON
OFF
Determine how the printer reacts to errors.
ON
:
If an error occurs that prevents printing, the
message will display, and the printer will go
offline for 10 seconds before returning online.
OFF
:
If an error occurs that prevents printing,
the message will remain on the display and the
printer will remain offline until G
O
is pressed.
If the printer is on a network, you will probably
want to turn
AUTO CONTINUE
to
ON
.
JAM RECOVERY=
AUTO
AUTO
ON
OFF
Determine how the printer behaves when a
paper jam occurs.
AUTO
: The printer automatically selects the
best mode for printer jam recovery (usually
ON
).
This is the default setting.
ON
: The printer automatically reprints pages
after a paper jam is cleared.
OFF
: The printer does not reprint pages
following a paper jam. Printing performance
might be increased with this setting.
MAINTENANCE
MESSAGE=OFF
OFF
This item appears only after the
PERFORM
PRINTER MAINTENANCE
message displays.
OFF
: The
PERFORM PRINTER MAINTENANCE
message will be cleared but will return after 5%
of the printer maintenance interval if the printer
has been used without a new printer
maintenance kit being installed.
The message should be turned off only while
waiting for the printer maintenance kit to be
installed. If the required maintenance is not
performed, the printer’s performance will
degrade.
For more information, see “Performing
preventative maintenance” on page 93. To
order the Printer Maintenance Kit, see
“Ordering information” page 22.
Configuration Menu (continued)
Item Values Explanation
To Next Page
Loading...
