HP LaserJet 4100 - Page 228

226 Appendix B - Control panel menus
EN
CFG IPX/SPX=NO NO
YES
Select whether you want to access the IPX/
SPX menu and set IPX/SPX protocol
parameters.
NO
: Bypass the IPX/SPX menu items.
YES
: Access the IPX/SPX menu items.
In the IPX/SPX menu, you can specify the
frame type parameter used on your network.
The default is
AUTO
, to automatically set and
limit the frame type to the first one detected.
For Ethernet cards, frame type selections
include
EN_8023
,
EN_II
,
EN_8022
,
EN_SNAP
.
For Token Ring cards, frame type selections
include
TR_8022
,
TR_SNAP
.
In the IPX/SPX menu for Token Ring cards, you
can also specify NetWare Source Routing
parameters, which include
SRC RT=AUTO
(default),
OFF
,
SINGLE R
, or
ALL RT
.
CFG TCP/IP=NO NO
YES
Select whether you want to access the TCP/IP
menu and set TCP/IP protocol parameters.
NO:
Bypass the TCP/IP menu items.
YES
: Access the TCP/IP menu items
In the TCP/IP Menu, you can specify
BOOTP=YES
or
DHCP=YES
for TCP/IP
parameters to be automatically loaded from a
bootP or DHCP server when the printer is
turned on.
If you specify
BOOTP=NO
and
DHCP=NO
, you
can manually set the following TCP/IP
parameters from the control panel: each byte
of the IP address (IP), Subnet Mask (SM),
Syslog Server (LG), and Default Gateway
(GW). You can also manually set the Idle
Timeout time period.
Print an HP JetDirect configuration page to
verify your settings. However, note that the print
server might overwrite selected parameters
with values that ensure proper operation.
EIO Menu (continued)
Item Values Explanation