56 Chapter 2 - Printing tasks
EN
Loading envelopes in tray 1
1 Open tray 1, but do not pull out the
extension. (Most envelopes feed
best without the extension. However,
oversize envelopes might need the
extension.)
2 Load up to 10 envelopes in the
center of tray 1 with the side-to-be-
printed facing up, and the postage-
end toward the printer. Slide the
envelopes into the printer as far as
they will go without forcing them.
3 Adjust the guides to touch the
envelope stack without bending the
envelopes. Make sure the envelopes
fit under the tabs on the guides.
Note
If envelopes curl, use the rear output bin
(see “Printing to the rear output bin” on
page 45).
1
2
3
To Next Page
Loading...
