150 Removing and replacing parts Q2431-90912
4. Locate the arrow (callout 2) that is embossed on the pickup gear cover near the optional
envelope feeder power connector (not shown; open tray 1 to locate this arrow). Use a small
flat-blade screwdriver to push in on the locking tab to release it
Figure 81. Right-side cover (3 of 4)
5. Open the formatter door and rotate the right-side cover away from the printer and lift it up to
remove it.
Figure 82. Right-side cover (4 of 4)
Reinstall note When you install the right-side cover, verify that the power-switch arm locks onto the switch
connecting rod (callout 3).
22
23
To Next Page
Loading...
