To load tray 2 or an optional 500-sheet tray
1. Pull the tray out and lift up slightly to remove it from the printer.
2. Pinch the release that is located on the left guide and slide the side guides to the correct
paper size.
3. Pinch the release that is located on the rear paper guide and slide it to the correct media
size.
4. On the right side of the tray, turn the knob to Standard for LTR (letter), A4, LGL (legal),
EXEC (executive), A5, or JIS B5 paper. Turn the knob to Custom for supported custom
paper sizes.
2
1
1 Standard position
2 Custom position
50 Chapter 2 Printing tasks ENWW
To Next Page
Loading...