2. Replace the plastic envelope-entrance cover in the printer and close tray 1.
Loading envelopes in the optional envelope feeder
Use these steps to load envelopes in the optional envelope feeder.
To load envelopes in the optional envelope feeder
1. Fold down the envelope-feeder tray. Lift the envelope weight.
2. Squeeze the release lever that is located on the left envelope guide and slide the guides
apart.
3. Load envelopes with the front side facing up, and the postage-end toward the printer.
Stack envelopes no higher than the arrows on the guides. Slide the envelopes into the
printer as far as they will go without forcing them. The envelopes at the bottom of the
stack should slide in slightly farther than the envelopes at the top of the stack.
60 Chapter 2 Printing tasks ENWW
To Next Page
Loading...