HP LaserJet 4250 Series - Page 80

6.
Use
(U P button) or (D OWN button) to scroll to INCHES or MILLIMETERS, and then
press
(S ELECT button). This selects the measurement units for determining the size of
your custom paper.
7.
Use
(U P button) or (D OWN button) to scroll to the correct dimension, and then press
(S ELECT button) to set the X dimension (the front edge of the paper, as shown in the
preceding figure). The X dimension can range from 76 to 216 mm (3 to 8.5 inches).
8.
Use
(U P button) or (D OWN button) to scroll to the proper dimension, and then press
(S ELECT button) to set the Y dimension (the side edge of the paper, as shown in the
preceding figure). The Y dimension can range from 127 to 356 mm (5 to 14 inches). For
example, if the custom paper is 203 x 254 mm, set X=203 mm and Y=254 mm.
68 Chapter 2 Printing tasks ENWW