5 Remove a fourth screw (callout 4), and then unplug the laser/scanner wire-harness (callout 5)
from the laser/scanner PCA.
5
4
Figure 6-45 Laser/scanner (3 of 3)
6 Carefully lift the laser/scanner up and out of the printer. Make sure that the laser/scanner
assembly does not catch or snag the wires along the bottom of the assembly when you remove
the assembly.
CAUTION When you reinstall the laser/scanner assembly, make sure that the wire-
harnesses are correctly routed through the cable guides. If the wire-harnesses are not
correctly routed, they can be damaged when the top cover is installed.
Main assemblies 221
To Next Page
Loading...