Paper-pickup drive assembly
1 Remove the following assemblies:
● Rear accessory cover. See
Accessory covers and the tray 2 extension door.
● Top cover. See
Top cover.
● Right-side cover. See
Right-side cover.
● Formatter cover. See
Formatter cover
● Formatter. See
Formatter assembly
● Tray 2 extension cover and duplexer accessory cover. See
Accessory covers and the tray 2
extension door
2 Remove two screws (callout 1).
3 Slide the power-supply PCA guide (callout 2) towards the rear of the printer and remove it.
Figure 6-46 Paper pickup-drive assembly (1 of 5)
222 6 Removing and replacing parts
To Next Page
Loading...