Item Values Explanation
EXECUTIVE (JIS)
DPOSTCARD (JIS)
16K
ENVELOPE 10
ENVELOPE MONARCH
ENVELOPE C5
ENVELOPE DL
ENVELOPE B5
CUSTOM
DEFAULT
CUSTOM PAPER
SIZE
UNIT OF MEASURE
X DIMENSION
Y DIMENSION
Use this item to set a default custom paper size for tray 1 or
any 500-sheet tray. This menu appears only if the Custom-
Standard switch in the selected tray is set to Custom.
PAPER DESTINATION
*STANDARD TOP BIN
REAR BIN
STACKER BIN
Use this item to configure the output bin destination. Only
the optional bins that are installed appear on the menu.
DUPLEX
*OFF
ON
This item appears only if an optional duplex-printing
accessory is installed. Select ON to print on both sides
(duplex) or OFF to print on one side (simplex) of a sheet of
paper.
DUPLEX
BINDING (HP LaserJet
4250/4350 only)
*LONG EDGE
SHORT EDGE
Use this item to change the binding edge for duplex printing.
The menu item appears if an optional duplex-printing
accessory is installed in the printer and DUPLEX=ON.
OVERRIDE
A4/LETTER
NO
*YES
Use this item to allow the printer to print an A4-size job on
letter-size paper if A4-size paper is not loaded in the printer
(or vice versa).
MANUAL FEED
*OFF
ON
Use this item to feed the paper manually from tray 1, rather
than automatically from a tray. If MANUAL FEED=ON and
tray 1 is empty, the printer goes offline when it receives a
print job. MANUALLY FEED [PAPER SIZE] appears on the
printer control-panel display.
EDGE-TO-EDGE
OVERRIDE
*NO
YES
Use this item to turn the edge-to-edge mode on or off for all
print jobs.
COURIER FONT
*REGULAR
DARK
Use this item to select the version of Courier font to use:
REGULAR: The internal Courier font available on the
HP LaserJet 4 Series printers
DARK: The internal Courier font that is available on the
HP LaserJet III Series printers
WIDE A4
*NO Use this item to change the number of characters that can
be printed on a single line of A4-size paper.
Control-panel menus 69
To Next Page
Loading...