3 Click the column header of your choice (such as IP Address or Device Model) to arrange the list
of available devices in ascending or descending order.
4 Highlight the product to configure, and click Open Device.
5 From the sub-menu at the top of the HP Web Jetadmin screen, click Configuration.
6 Click the network link located on the left side of the configuration screen.
7 Type the new IP information. You might need to scroll down for more options.
8 Click Apply to save the settings.
9 Click the Refresh button located next to the question mark on the right side of the screen.
10 Verify the IP information by clicking Status Diagnostics or by printing a configuration page.
To change an IP address by using the embedded Web server
The MFP has an embedded Web server that can be used to modify the TCP/IP parameters. In order
to use the embedded Web server, the HP Jetdirect print server must have an IP address already
configured. On a network, this is done automatically during initial product installation.
1 In a supported Web browser, type the current IP address of the HP Jetdirect print server as the
URL. The Device Status page of the embedded Web server appears.
2 Click Networking. From this page, you can modify the MFP network configuration.
To change an IP address by using the control panel
You can manually configure or verify the IP address by using the control panel.
1 Press M
ENU
.
2 Touch CONFIGURE DEVICE.
3 Touch I/O.
4 Touch EMBEDDED JETDIRECT MENU or EIO JETDIRECT MENU, depending on which type of
network connection you are using.
5 Touch TCP/IP.
6 Touch CONFIG METHOD, and touch MANUAL.
7 Touch MANUAL SETTINGS
8 Touch IP ADDRESS
9 Touch the left arrow or the right arrow to highlight each segment of the IP address.
10 Use the numeric keypad to type the digits in each segment of the IP address.
11 Touch OK to save the IP address.
72 4 Maintenance
To Next Page
Loading...