Residual-media jam
If the top-of-page sensor (PS103), the fuser-delivery sensor (PS108), or the reversing-unit jam
sensor (PS111) detects the leading edge of the media at the start of initial rotation, the
microprocessor on the dc controller PCA identifies a residual-media jam.
In addition, if the fuser-delivery sensor (PS108) does not detect the leading edge of the media, within
2.1 seconds after the top-of-page sensor (PS103) detects the leading edge, the microprocessor on
the dc controller PCA identifies a residual-media jam.
Whenever the MFP is turned on or a print sequence begins, if the pre-feed sensor (PS102) detects
the presence of media, an automatic-delivery request is sent to the formatter. The dc controller PCA
drives each motor, and the residual media is delivered to the output bin. Normal printing can continue.
Pickup, feed, and delivery system 121
To Next Page
Loading...