Before performing service
■ If possible, print a menu map and configuration page. See Information pages.
■ Remove all of the accessories and print media, the print cartridge, and tray 2 from the MFP.
■ Unplug the power cord from the power outlet at the wall receptacle.
■ Place the MFP on an ESD mat, if one is available. If an ESD-protected workstation is not
available, discharge body static by grasping the MFP chassis before touching an ESD-sensitive
component. Ground the MFP chassis before servicing the MFP.
After completing service
■ Reinstall the print cartridge.
CAUTION Do not transport the MFP while the print cartridge is installed.
■ Reconnect all cables to the MFP.
■ Replace all of the accessories and load the media.
■ Print a configuration page and verify that the latest firmware is installed on the MFP.
Removal and replacement strategy 145
To Next Page
Loading...