Hard drive
WARNING! The MFP contains components that are sensitive to electrostatic discharge
(ESD). Always perform service work at an ESD-protected workstation. If an ESD-protected
workstation is not available, discharge body static by grasping the MFP chassis before
touching an ESD-sensitive component. Ground the MFP chassis before servicing the MFP.
1 Remove the formatter cover, and open the formatter-cage door. See Formatter cover and
formatter.
2 Disconnect the flat, flexible cable (FFC) (callout 1) from the hard drive.
Figure 6-33 Remove the hard drive (1 of 2)
168 6 Removal and replacement
To Next Page
Loading...