3 Unhook the lifter-drive-assembly tension-spring from the tab on the chassis. Remove one screw
(callout 1), and then remove the sheet metal bracket.
CAUTION The lifter-drive-assembly tension-spring is not captive. Do not lose the spring
when you remove the assembly.
Figure 6-124 Remove the registration assembly (2 of 6)
4 Remove the wire harnesses from the wire guides, remove five screws (callout 2), and then
remove the drive-gear assembly.
Figure 6-125 Remove the registration assembly (3 of 6)
224 6 Removal and replacement
To Next Page
Loading...