5 On the dc controller, disconnect two FFCs (callout 4; J80, J81), the 24-volt connector (callout 5;
J99) the duplexer connector (callout 6; J44), and the fuser connector (callout 7; J71).
Figure 6-152 Remove the engine power supply (4 of 10)
6 Remove the cassette from tray 2. Remove two screws (callout 8), release the retaining tab
(callout 9), and slide the rear duplexer-guide toward you and remove it.
Figure 6-153 Remove the engine power supply (5 of 10)
Internal assemblies 241
To Next Page
Loading...