Tray 2 detection switch
1 Remove the PFC power supply. See Power-factor-correction (PFC) power supply.
2 Remove the cassette from tray 2.
3 Remove three screws (callout 1), release the two locking tabs on the tray detection switch
(callout 2), and then remove the tray 2 detection switch.
1
2
Figure 6-161 Remove the tray 2 detection switch
CAUTION The tray 2 detection-switch spring is not captive. Do not lose this spring when
you remove the switch.
Internal assemblies 247
To Next Page
Loading...