5 Flex the side of the scanner chassis to release the optical-unit guide-rod from the scanner
chassis.
Figure 6-190 Remove the optical unit (4 of 7)
6 Tilt the optical unit up, and slide the guide-rod out of the mounting hole in the chassis and
through the optical unit.
CAUTION Do not touch the lamp. Skin oils and finger print cause image-quality
problems, and the lamp might burn and be damaged when the MFP power is turned on.
Figure 6-191 Remove the optical unit (5 of 7)
266 6 Removal and replacement
To Next Page
Loading...