Security features
■ Foreign Interface Harness (FIH)
■ Secure Disk Erase
■ Security lock
■ Job retention (password protected)
■ HP DSS authentication
■ Control-panel lock (by using Web Jetadmin)
Minimum system requirements for e-mail functionality
To use the e-mail functionality, the MFP must be connected to an IP-based server that has simple
mail transfer protocol (SMTP). This server can either be on the local area network or at an outside
Internet service provider (ISP). HP recommends that the MFP be located on the same local area
network (LAN) as the SMTP server. When using an ISP, you must connect to the ISP by using a
digital subscriber line (DSL) connection. When obtaining e-mail services from an ISP, ask the ISP to
provide the correct SMTP address. Dial-up connections are not supported. If no SMTP server is on
the network, third-party software is available that allows you to create an SMTP server. However,
purchase and support of this software is the customer's responsibility.
Features and benefits of the MFP 7
To Next Page
Loading...