Clearing jams from the ADF
Use this procedure to clear jams from the ADF.
1 Lift the ADF-input tray, and check for jammed media underneath the tray. Carefully remove any
jammed media.
2 Pull up on the ADF-cover-release lever, and open the ADF cover. Carefully remove any jammed
media.
3 Lift up on the ADF-document guide, and check for jammed media. Carefully remove any jammed
media.
4 Close the ADF cover.
5 If a jam message persists, jammed media is still in the MFP. Look for the jam in another location.
Jams 353
To Next Page
Loading...