Blurred print
Possible cause Solution
1 The media does not meet specifications or is not
stored correctly.
1 Turn over the stack of media in the tray. Also try
rotating the media 180 degrees.
2 Check the media type and quality. Replace the
media if it does not meet specifications, and
advise the customer to use the HP-
recommended media and to store it correctly.
See
Media specifications.
2 The operating environment does not meet
specifications.
Make sure that the MFP is installed in an area that
meets the environmental specifications. See
Environmental specifications.
3 The toner-density setting is incorrect. Open the PRINT QUALITY menu at the control panel
and adjust the toner-density setting.
4 The high-transfer setting is turned off. Open the PRINT QUALITY menu at the control
panel. Select OPTIMIZE and set HIGH
TRANSFER=ON.
5 The line detail setting is turned off. Open the PRINT QUALITY menu at the control
panel. Select OPTIMIZE and set LINE DETAIL=ON.
386 7 Troubleshooting
To Next Page
Loading...