Labels
CAUTION To avoid damaging the MFP, use only labels that are recommended for use in
laser printers. Never print on the same sheet of labels more than once or print on a partial
sheet of labels.
Label construction
When selecting labels, consider the quality of each component:
■ Adhesives: The adhesive material should be stable at 200°C (392°F), the MFP's fusing
temperature.
■ Arrangement: Only use labels that have no exposed backing between them. Labels can peel off
sheets that have spaces between the labels, causing serious jams.
■ Curl: Prior to printing, labels must lie flat with no more than 13 mm (0.5 inch) of curl in any
direction.
■ Condition: Do not use sheets of labels that have wrinkles, bubbles, or other indications of
separation.
NOTE Select labels in the printer driver.
Transparencies
Transparencies used in the MFP must be able to withstand 200°C (392°F), the MFP's fusing
temperature.
CAUTION To avoid damaging the MFP, use only transparencies recommended for use in
HP LaserJet printers, such as HP-brand transparencies. (For ordering information, see
How to
order parts, supplies, and accessories.)
NOTE Select transparencies in the printer driver.
22 1 Product information
To Next Page
Loading...