Removal and Replacement
Left Side Assemblies
4. Grasp the Formatter PCA near the center and. pull straight out
(the PCA is plugged into the DC Controller through the
connector in the lower center area).
h[nf@
When replacing the Formatter PCA, remove and
5.
6.
transfer the Formatter to DC Controller
Connector Extension (all printers) and the
Switch Actuator (LaserJet 4L/4ML) to the new
. PCA. Procedures are shown below.
To remove the connector extension, squeeze the tabs on either
side and pull the Extension straight out the rear of the PCA
(Figure 6-14, callout 1).
LaserJet 4L /4ML: Saueeze the tabs on the Switch Actuator and
6-16
To Next Page
Loading...