5.
Press the two release tabs on either side of the pickup assembly
(callout
3
in Figure 19) and pull the assembly away from the
printer. (The left side release tab is partially hidden from view.
Pressing in on both sides will release the tabs.)
6.
Pull the pickup assembly straight out from the back of the
printer.
7.
To remove the roller from the pickup assembly, grasp the tabs
on the right end of the roller and slide it to the right (shown in
Figure 23).
Figure 22 Tray 1 Pickup Assembly Locations.
HP LaserJet 5P/5MP, 6P/6MP Printer Service Supplement
Removal and Replacement
50
To Next Page
Loading...