Testing the Installation
After completing the setup process, test your HP LaserJet 6L printer, HP
LaserJet Companion, and the PaperPort software to ensure the setup
was successful.
Printing a self-test page with your HP LaserJet 6L
Printer
A self-test page can be useful in identifying your printer’s configuration
and to ensure that your printer is working properly.
To print a self-test page
1 Make sure that the Ready light is on and all other lights are off. If
necessary, wake up the printer by briefly pressing and releasing the
Front Panel button.
2 Now briefly press and release the Front Panel button again. The Data
light comes on and the Ready light blinks. Please wait for a self-test
page to print.
If the self-test page does not print, try the following:
1 Ensure that paper is loaded in the printer.
2 Check the printer’s Front Panel Indicator lights to determine the status of
your printer. Then, refer to “Printer Messages” later in this chapter.
3 Contact Customer Support for assistance (refer to the support pages at
the front of this manual for support options).
1
Installation
EN Set Up 1-15
To Next Page
Loading...