To test the Companion’s installation
Note
Before testing the Companion’s installation, see the precautions listed in
chapter 3, “Before Using the HP LaserJet Companion.”
1 Raise the paper tray and paper supports.
2 Place a document, face forward and top down, in the paper tray. Adjust
the paper edge guides by sliding them to the edges of the document.
3 Press [To[Printer] once. The feed mechanism will pull the page through
the HP LaserJet Companion. A copy of the page prints at your printer.
If you need to stop the page, press [To[Printer] again. To remove the
page, see chapter 5,“Clearing Paper Jams from the HP LaserJet
Companion.”
Note
The HP LaserJet Companion does not support the Direct Copy feature
for network printers. For more information on the Direct Copy feature,
see chapter 3, “Using the Direct Copy Feature.”
Figure 1-4
Figure 1-5
1-16 Set Up EN
To Next Page
Loading...