To discontinue DHCP configuration
CAUTION
Changes to an IP address on your printer may require updates to printer or system printing
configurations for clients or servers. If you do not want your printer configured through
DHCP, you must reconfigure the printer with a different configuration method. You can
manually modify the TCP/IP parameters through a supported Web browser using the
printer's embedded Web server, the printer's control panel, or HP Toolbox. If you change to
BOOTP configuration, the DHCP-configured parameters are released and the TCP/IP
protocol is initialized. If you change to Manual configuration, the DHCP-configured IP
address is released and the user-specified IP parameters are used. Therefore, if you
manually provide the IP address, you should also manually set all of the configuration
parameters, such as subnet mask and default gateway.
36 Chapter 3 Networking ENWW
To Next Page
Loading...
