NOTE The Restore Factory Settings menu item in the printer control panel menu will not
reset the HP Jetdirect print server. After resetting to factory default values, print a Jetdirect
configuration page to confirm that factory-reset values have been assigned.
To perform a cold reset:
1 Turn the printer on and watch for the memory count to begin.
2
Press and hold the Select
button until the three control panel lights (Ready, Data, Attention)
blink and then remain on.
3
Release the Select
button. The control panel will display Select Language.
4
Press the down arrow
M
button until Cold Reset appears.
5
Press the Select
button to perform a cold reset and then continue its power-on sequence.
Disabling the Embedded LAN
For fault isolation to either printer or networking components, you can disable the Jetdirect
embedded network interface. To disable the network components, follow these steps:
1 Turn the printer on and watch for the memory count to begin.
2
Press and hold the Select
button until the three control panel lights (Ready, Data,Attention)
blink and then remain on.
3
Release the Select
button. The control panel will display Select Language.
4
Press the down arrow
M
button until Disable Embedded LAN appears.
5
Press the Select
button. The embedded networking components will be disabled, and the
printer will continue its power-on sequence.
NOTE To enable the embedded network interface, use the same procedures, except choose
Enable Embedded LAN in step 4 above.
66 Chapter 6 Troubleshooting the HP Jetdirect Print Server ENWW
To Next Page
Loading...