Message Description
DOMAIN NAME:
The Domain Name System (DNS) name of the domain in which the HP Jetdirect print
server resides (for example, support.company.com). It is not the fully qualified DNS
name (for example, printer1.support.company.com) because the host printer name is
not included.
NOT SPECIFIED: Indicates that a domain name has not been configured on the print
server.
PRIMARY DNS SERVER:
The IP address of the primary Domain Name System (DNS) server.
NOT SPECIFIED: Indicates that a primary DNS server has not been configured on the
print server.
SECONDARY DNS SERVER: The IP address of the secondary Domain Name System (DNS) server.
NOT SPECIFIED: Indicates that a secondary DNS server has not been configured on
the print server.
WINS SERVER:
The IP address of the Windows Internet Name Service (WINS) server.
NOT SPECIFIED: Indicates that a WINS server's IP address has not been configured
on the print server.
SYSLOG SERVER:
The IP address of the syslog server configured on the print server.
NOT SPECIFIED: Indicates that a syslog server has not been configured.
IDLE TIMEOUT:
The timeout value expressed in seconds after which the print server closes an idle TCP
print data connection. Acceptable values are integers between 0 and 3600. A value of
zero turns off the timeout mechanism. The default value is 270 seconds.
SLP:
Specifies whether the HP Jetdirect print server sends Service Location Protocol (SLP)
packets used by system applications for automated installation.
ENABLED: The print server sends SLP packets.
DISABLED: The print server does not send SLP packets.
WEB JETADMIN URL:
If the HP Jetdirect print server is found on the network by HP Web Jetadmin, the URL of
the host system used for HP Web Jetadmin services is displayed. The URL is limited to
two lines and may be truncated.
NOT SPECIFIED: Indicates that the URL of the Web Jetadmin host system could not be
identified or is not configured.
MDNS SERVICE NAME: Specifies an alphanumeric string of up to 64 ASCII characters assigned to this device or
service. This name is persistent and is used to resolve a particular device or service if
socket information (such as the IP address) changes from session to session. Apple
Rendezvous will display this service. The default service name is the printer model and
the last six digits of LAN Hardware (MAC) address.
Error Messages
Error codes and messages that may appear in the Status sections of the Jetdirect configuration page
are described in the following table.
Table 7-4 TCP/IP Configuration Information (continued)
ENWW Error Messages 79
To Next Page
Loading...