Message Description
169.254/16 or 192.0.0.192 is assigned if a valid IP address cannot be obtained over the
network after 2 minutes.
NOT SPECIFIED: Indicates that an IP address is not assigned or the value is zero.
SUBNET MASK:
The IP subnet mask configured on the HP Jetdirect print server. During initialization, a
temporary value 0.0.0.0 is displayed. Depending on configuration parameters, the print
server may automatically assign a usable default value.
NOT SPECIFIED: Indicates that a subnet mask is not configured.
DEFAULT GATEWAY:
The IP address of the gateway used when sending packets off the local network. Only
one default gateway may be configured. During initialization, a temporary value 0.0.0.0
is displayed. If not provided, the IP address of the Jetdirect print server is used.
NOT SPECIFIED: Indicates that a default gateway is not configured.
CONFIG BY:
Identifies how the HP Jetdirect print server obtained its IP configuration:
BOOTP: Automatic configuration through a BOOTP server.
BOOTP/TFTP: Automatic configuration through a BOOTP server and TFTP
configuration file.
DHCP: Automatic configuration through a DHCP server
DHCP/TFTP: Automatic configuration through a DHCP server and TFTP configuration
file.
RARP: Automatic configuration through the Reverse Address Resolution Protocol.
USER SPECIFIED: Manual configuration through Telnet, the printer's control panel, HP
Web Jetadmin, embedded Web server, or other method.
DEFAULT IP: The default IP address was assigned. This address may not be a valid
address for your network.
AUTO IP: A link-local IP address (169.254.x.x) was assigned. If the network is a link-
local network, this address should be valid.
NOT CONFIGURED: The print server was not configured with IP parameters. Verify
that TCP/IP is enabled, or check for error status.
BOOTP SERVER: or DHCP
SERVER: or RARP SERVER:
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It specifies the
IP address of the system that responds to the HP Jetdirect print server's request for
automatic TCP/IP configuration over the network.
NOT SPECIFIED: Indicates that the configuration server's IP address could not be
determined or was set to zero in the response packet.
BOOTP/DHCP SERVER: Displayed during initialization while the HP Jetdirect print server attempts to obtain its
TCP/IP configuration from a BOOTP or DHCP server. The temporary address displayed
is 0.0.0.0.
TFTP SERVER:
The IP address of the system where the TFTP configuration file is located. During
initialization, the temporary address 0.0.0.0 is displayed.
NOT SPECIFIED: Indicates that a TFTP server has not been not been set.
CONFIG FILE:
The name of the HP Jetdirect configuration file. The file pathname may be truncated to
fit on two lines.
NOT SPECIFIED: Indicates that a file was not specified in the BOOTP reply from the
host.
Table 7-4 TCP/IP Configuration Information (continued)
78 Chapter 7 HP Jetdirect Configuration Page ENWW
To Next Page
Loading...