Table 7-3 Network Statistics
Message Description
TOTAL PACKETS RECEIVED:
Total number of frames (packets) received by the HP Jetdirect print server without error.
This includes broadcast, multicast packets, and packets specifically addressed to the
print server. This number does not include packets specifically addressed to other nodes.
UNICAST PACKETS RECEIVED:
Number of frames specifically addressed to this HP Jetdirect print server. This does not
include broadcasts or multicasts.
BAD PACKETS RECEIVED:
Total number of frames (packets) received with errors by the HP Jetdirect print server.
FRAMING ERRORS RECEIVED:
Maximum of CRC (Cyclic Redundancy Check) errors and framing errors. CRC errors
are frames received with CRC errors. Framing errors are frames received with
alignment errors. A large number of framing errors could indicate a cabling problem with
your network.
TOTAL PACKETS
TRANSMITTED:
Total number of frames (packets) transmitted without error.
UNSENDABLE PACKETS:
Total number of frames (packets) not successfully transmitted because of errors.
TRANSMIT COLLISIONS:
Number of frames not transmitted because of repeated collisions.
TRANSMIT LATE COLLISIONS:
Total number of frames not transmitted because a late collision occurred. Late collisions
often occur when cable lengths exceed network specifications. A large number may
indicate a cabling problem on the network.
TCP/IP Protocol Information
Information in this section of the Jetdirect configuration page is described in Table 7-4 TCP/IP
Configuration Information. For error messages, see Table 7-5 Error Messages.
Table 7-4 TCP/IP Configuration Information
Message Description
STATUS:
Current TCP status.
READY: Indicates the HP Jetdirect print server is awaiting data over TCP/IP.
DISABLED: Indicates that TCP/IP was manually disabled.
INITIALIZING: Indicates that the print server is searching for the BOOTP server, or
trying to get the configuration file through TFTP. An additional status message may also
be displayed.
An error code and message is displayed if the print server is not ready. For more
information, see
Table 7-5 Error Messages.
HOST NAME:
The host name configured on the print server. It may be truncated.
NOT SPECIFIED: Indicates that no host name was specified in a BOOTP response or
TFTP configuration file.
NPIxxxxxx: The default name is NPIxxxxxx, where xxxxxx represents the last six digits
of the LAN hardware (MAC) address.
IP ADDRESS:
The Internet Protocol (IP) address assigned to the HP Jetdirect print server. This is a
required entry for operation of the print server on a TCP/IP network. During initialization,
a temporary value 0.0.0.0 is displayed. For initial installations, a default IP address
ENWW Configuration Page Messages 77
To Next Page
Loading...