Plug-and-Play installation for a direct USB connection in Microsoft Windows Me
Up to five events might occur when you use Microsoft Windows Plug-and-Play to install the HP LaserJet
P2010 Series print driver software on a computer running Microsoft Windows Me.
NOTE: The SETUP.EXE program on the HP LaserJet P2010 Series printing-system CD is not
supported in Windows 98 SE or Windows Me. For these operating systems, use Microsoft Plug-and-
Play for direct USB connections or the Add Printer wizard installation for network connections to install
the print drivers. If you run SETUP.EXE in these operating systems, an error message appears: The
operating system on this computer is not supported.
Follow these steps to install the HP LaserJet P2010 Series printing-system software on a computer
running Microsoft Windows Me.
1. Verify that the HP LaserJet P2010 Series printer is turned on.
2. Quit all open programs.
3. Insert the HP LaserJet P2010 Series printing-system CD into the CD-ROM drive on the computer.
NOTE: If a dialog box that contains an Install Printer Software button appears, click Exit and
continue with step 4.
4. Connect a USB cable between the printer and the computer.
5. When the New Hardware Wizard dialog box appears, click Automatic search for a better driver.
(Recommended), and then click Next.
6. Click Finish in the USB Printing Support dialog box.
7. In the HP EWS dialog box, click the Automatic search for a better driver (Recommended) option
button and then click Next to continue the installation.
8. Click Finish to continue copying files to the computer.
9. Click Start, click Settings, and then click Printers to confirm that the HP LaserJet P2010 Series
print driver is installed.
40 Chapter 3 Install Windows printing-system components ENWW
To Next Page
Loading...
