Rotating Motor
Description
The product is executing a component test and the component selected is a motor.
Recommended action
Press the Stop button
when ready to stop this test.
To exit press
Size mismatch in Tray <X>
Description
The paper in the listed tray does not match the size specified for that tray.
Recommended action
1. Load the correct paper.
2. Verify that the paper is positioned correctly.
3. Close the tray and verify that the control panel lists the correct paper size and type. Reconfigure
the size and type if necessary.
4. If necessary, use the control-panel menus to reconfigure the size and type settings for the specified
tray.
Sleep mode on
Description
The product is in sleep mode. Pressing a control-panel button, receiving of a print job, or an error
condition clears this message.
Recommended action
No action necessary.
Standard top output bin full Remove all paper from bin
Description
The specified output bin is full and must be emptied for printing to continue.
Recommended action
Empty the specified output bin.
Staple Cartridge low
Description
The product indicates when a supply level is low.
ENWW
Tools for troubleshooting
317
To Next Page
Loading...